How To Repair Small Leaks in Glass Aquariums

How To Repair Small Leaks in Glass Aquariums in 9 Easy Steps

 

With a few inexpensive items and a little time you can easily repair small or minor leaks in a glass aquarium using these simple instructions from your Guides.
Here's How:

   1. Locate the exact source of the leak and mark it with a felt tip marker.
   2. Reduce the water level in the tank until the leak stops.
   3. Thoroughly dry and clean the area of and around the leak with a paper towel, or soft cloth.
   4. With the razor blade, scrape the existing silicone from the leaking area, and an additional one inch area around the source of the leak.
   5. Clean the scraped area with the acetone applied to a paper towel, being careful not to over staturate it or allow any acetone to run or drip down into the aquarium, and let dry for a few minutes.
   6. Apply the silicone sealant to the cleaned area, working it into the glass joint area.
   7. Allow the silicone to cure for at least 12 hours, 24 is better.
   8. Refill the tank with water to the desired level.
   9. Check to see if the repair worked and the leak has stopped.

 

Tips:

   1. Not all sealants are suitable for aquarium use. Use only non-toxic 100% silicone sealants, such All-Glass® brand.
   2. Pinpoint the exact location of the leak. Water will be at the bottom of the tank (gravity rules), but most likely the source of the leak will be somewhere else up higher or sideways along the joint or seam.
   3. If patching the leak from the outside of the tank does not stop the leak, try patching it from the inside.

What You Need:

 

    * 100% Silicone Sealant
    * Acetone
    * Single Edged Razor Blades
    * Paper Towels
    * Felt Tip Marker
    * Tank Replacement Water

 

From Stan & Debbie Hauter,
Your Guide to Saltwater Aquariums.

 

Cara memperbaiki aquarium yang bocor hampir mirip kita membuat aquarium baru, untuk yang bocor sedikit kita tinggal kelupas lem silicon yang ada disekitar kebocoran tersebut, namun jika yang bocor hampir satu sisi kita harus ambil semua lem yang ada dalam satu sisi tersebut, baru dilakukan pengeleman.

Kalau pun kita tidak kelupas lem lama, maka tambalan kita tidak akan bertahan lama. Saat akan di lem, pastikan kondisi semua bagian dalam keadaan kering, dan sebaiknya semua air memang dikuras, karena tekanan air akan menjadikan bocoran semakin melebar.